Skip to clock selection
Synerion
Synerion customersTime clock customer portal

Your next time clock starts here.

Choose your clocks and requested options. Synerion will review the configuration and send an order form for signoff.

A request, not a checkout.

Your account manager will review your selections and send an order form for signoff. No payment is collected here. Compatibility and final configuration are confirmed before you sign.

Choose your clocks

01 / Choose and configure

The right clock for your location.

Select a model, set the quantity, and choose any requested options. Add another configuration if you need different models or add-ons.

Synerion Fusion time clock
Synerion Fusion

An 8-inch biometric clock

A touchscreen terminal with face, fingerprint, and badge options for your configured time capture setup.

8-inch touchscreenFace identificationFingerprint optionHID / RFID optionsEthernet
Product sheet (PDF)
Requested add-ons

Optional. Applied to each clock in this configuration.

PoE+ is included. Reader selection must match the configuration Synerion confirms on your order form.

02 / Review and request

Your clock request.

Review your quantities and options, then tell us who should receive the order form.

Who should we contact?

Fields marked with an asterisk are required.

Please do not include employee records, biometric data, passwords, or payment details.

Your details are sent only when you select “Submit order request” on the next step.

03 / Install with the right instructions

Resources for every clock.

Download the product sheet for your model. Installation guidance is model-specific. Confirm the instructions match the unit and configuration you receive.

Silent walkthrough with on-screen instructions.

Install Fusion, step by step.

This walkthrough uses the supplied Fusion front panel guide. It covers positioning, cable routing, the seven mounting steps, and enrollment considerations.

Check local accessibility requirements before choosing the camera height. Do not remove the optical tamper reflective strip.

Open the full guide
Read the Fusion mounting steps

The mounting instructions below are extracted from the supplied guide. Read the full PDF for the diagrams, positioning guidance, and other installation information.

  1. 1. Release the bracket

    Remove wall bracket securing screw to release wall bracket from Fusion.

  2. 2. Mark the fixing points

    With the wall bracket against the wall, mark the four screw mount fixing points (C) and the preferred cable routing position.

  3. 3. Fit the wall bracket

    Drill holes in the wall and mount the wall bracket with screws taking care to feed the cables through the bracket aperture.

  4. 4. Connect the cables

    Offer the Fusion unit close to the wall bracket and connect Ethernet and/or power cables.

  5. 5. Align the terminal

    Position the Fusion unit slightly above the wall bracket with its back parallel with the wall and make sure all cables are free to move.

  6. 6. Slide onto the bracket

    Centralize the Fusion unit against the wall bracket and slowly lower the terminal by sliding it down the wall until metal tangs ‘A’ engage into slots ‘B’.

  7. 7. Secure the base screw

    With the terminal fully down until it stops against the wall bracket re-fit the M4 screw in the base making sure to press the lower portion of the terminal into the wall to make sure it sits snug against the wall.